MP Pumps 38299 FLOMAX Stainless Steel 4 x 3in Self-Priming Centrifugal Pump

Basic Info

Warranty Info

Literature

Rebate Info

Video

Brand
MP Pump

Manufacturer
Gardner Denver

Manufacturer Part Number
38299

Special Order
No

Exportable
Yes

HTS Code
8413.91.9096

Country of Origin
United States of America

Rating
Nobody has rated this Product yet. Review This Product

Quantity in Stock
0

On Order
0.00

Your Price
$7,542.56

Qty

MP Pumps 38299 FLOMAX Stainless Steel 4 x 3in Self-Priming Centrifugal Pump

The FLOMAX line is a self-priming centrifugal pump series built for general industrial, agricultural, and marine transfer duty. Once primed, an internal flapper check valve holds a column of liquid in the suction line so the pump can re-prime on the next start without manual assistance.

Suction and discharge connections are 4 x 3 inch. Wetted construction is stainless steel. This model is configured for close-coupled motor, sized for a 286TSC motor frame with a 7.0 inch impeller, and is rated to move up to 500 GPM.

Always match by the MP Pumps part number 38299 stamped on the unit or listed on your equipment parts diagram, since pump configurations vary by mount type, material, and port size even within the same series.

Key Features

Self-priming centrifugal design, capable of lifting liquid from several feet below the pump on a dry start
Internal flapper check valve maintains suction-line prime between duty cycles
Available in bronze or cast iron construction depending on the model
PumPak versions are a factory-assembled, run-tested pump end ready to couple to a motor, engine, or hydraulic drive

Applications

General industrial and agricultural liquid transfer
Marine bilge, deck wash, and utility transfer service
Water transfer where self-priming operation is required
OEM and replacement service on FLOMAX-equipped equipment

Specifications

Manufacturer: MP Pumps
Part Number: 38299
Series: FLOMAX
Part Type: Pump
Construction: Stainless Steel
Port Size: 4 x 3 inch
Mount Type: Close-coupled Motor
Motor Frame: 286TSC
Impeller Diameter: 7.0 inch
Rated Capacity: up to 500 GPM

Frequently Asked Questions

Q: How do I know this is the right pump for my equipment?
Match it by the MP Pumps part number stamped on the unit or listed on your equipment parts diagram. Send us a picture of your pump plate and we will confirm fitment.
Q: What does self-priming mean for this pump?
A self-priming pump can clear air from its own suction line on startup rather than needing the line pre-filled with liquid, using an internal check valve to hold prime between runs.
Q: Can this pump run dry?
No. Running a centrifugal pump dry for more than a few seconds can damage the mechanical seal and impeller. Shut the pump off if it loses prime and will not reprime on its own.
Q: Is this a genuine MP Pumps part?
Yes, this is a genuine MP Pumps unit, sold under MP Pumps part number 38299.

Not sure this is the right part? Send us a picture of your Pump Plate to https://www.clrmarine.com/Contact-Us and the CLR Marine team will confirm the correct pump.